Cisco Systems PA-4T Instrukcja Użytkownika Pobierz pdf (Strona 23)

CHAPTER

Preparing for Installation 2-1

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing

the PA-4T+ port adapter.

• Tools and Parts Required, page 2-1

• Software and Hardware Requirements, page 2-2

• Safety Guidelines, page 2-3

• FCC Class B Compliance, page 2-5

Tools and Parts Required

You need the following tools and parts to install a port adapter. If you need additional equipment,

contact a service representative for ordering information.

• PA-4T+(=) port adapter and one of the following:

— VIP2-15(=) if you are installing only one PA-4T+; otherwise, we recommend a VIP2-40(=)

or VIP2-50(=)

— Cisco 7200 series router with at least one available port adapter slot

— Cisco uBR7200 series router with at least one available port adapter slot

— Cisco 7100 series router with at least one available port adapter slot

• Serial cables appropriate for the desired port adapter interface types and the desired modes. (See

the “LEDs” section on page 1-15.)

• Number 1 Phillips and a 3/16-inch, ﬂat-blade screwdriver.

• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist

strap included with all upgrade kits, ﬁeld-replaceable units (FRUs), and spares.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Brak uwag

Cisco Systems PA-4T Instrukcja Użytkownika Strona 23