Cisco Systems PA-4T Instrukcja Użytkownika Pobierz pdf (Strona 71)

Configuring the PA-4T+ Interfaces 8-17

Using show Commands to Display Interface Information

The show version (or show hardware) command displays the conﬁguration of the system hardware

(the number of each port adapter type installed), the software version, the names and sources of

conﬁguration ﬁles, and the boot images. Following is an example of the show version command:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) 7200 Software (C7200-J-M), RELEASED VERSION 11.1(8)CA [sglee 108]

Synced to mainline version: 11.1

Compiled Thu 27-Feb-97 23:54 by sglee

Image text-base: 0x600088F0, data-base: 0x6072C000

ROM: System Bootstrap, Version 11.1(5) RELEASED SOFTWARE

ROM: 7200 Software (software-image), Released Version 11.1(8)CA [sglee 101]

pulp uptime is 2 hours, 19 minutes

System restarted by reload

System image file is “image-name”, booted via tftp from 10.10.10.1

cisco 7206 (NPE150) processor with 26624K/6144K bytes of memory.

R4700 processor, Implementation 33, Revision 1.0 (512KB Level 2 Cache)

Last reset from power-on

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

Chassis Interface.

3 Ethernet/IEEE 802.3 interfaces.

1 FastEthernet/IEEE 802.3 interface.

4 Serial interfaces.

125K bytes of non-volatile configuration memory.

1024K bytes of packet SRAM memory.

8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).

4096K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x0

Use the show diag command to view all the port adapter types installed in your system. Use the

show diag slot command to view information about a port adapter installed in a speciﬁc port adapter

slot. In the following example, a PA-4T+ in port adapter slot 1 is used:

Router# show diag 1

Slot 1:

Mx serial port adapter, 4 ports

Port adapter is analyzed

Port adapter insertion time 02:19:52 ago

Hardware revision 1.0 Board revision UNKNOWN

Serial number 3701161 Part number 73-1577-03

Test history 0x0 RMA number 00-00-00

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 0C 01 00 00 38 79 A9 49 06 29 03 00 00 00 00

0x30: 05 00 00 00 FF FF FF 00 FF FF FF FF FF FF FF FF

For command descriptions and examples for Cisco 7200 series, Cisco 7100 series or

Cisco uBR7200 routers, refer to the publications listed in the “Related Documentation” section on

page vi. Proceed to the “Using ping and loopback Commands” section on page 8-21.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco Systems PA-4T Instrukcja Użytkownika Strona 71

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco Systems PA-4T