Cisco Systems SOLUTION ENGINE SOFTWARE RELEASE 2.5 Instrukcja Użytkownika Pobierz pdf (Strona 81)

4-19

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

78-15903-01

Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

The following optional commands are recommended:

width 80

length 24

Step 9 Exit global configuration mode, then enter the following command:

write memory

Set Up IOS Access Points by Using the Web Interface

Step 1 Log into the Web interface of the AP 1100 or AP 1210.

Step 2 Select SERVICES from the menu, then click CDP:

a. After Cisco Discovery Protocol (CDP), select Enabled.

b. Click Apply.

Note If you do not want to use CDP for discovery, see Discovering Devices,

page 4-30, for alternative methods.

Step 3 To push configuration templates to IOS access points, you can use either Telnet

or SSH (secure shell protocol). You must configure either Telnet or SSH; you can

configure both. See Steps 4 and 5 for procedures.

Step 4 To enable and configure SSH (secure shell protocol), enter the following:

a. Select SERVICES > Telnet/SSH.

b. Enable Secure Shell.

c. Enter a System Name.

d. Enter a Domain Name (for example, cisco.com).

e. (Optional) Enter the RSA key size

f. (Optional) Enter the Authentication Timeout.

g. (Optional) Enter Authentication Retries.

h. Click Apply.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 121 122

Brak uwag

Cisco Systems SOLUTION ENGINE SOFTWARE RELEASE 2.5 Instrukcja Użytkownika Strona 81