Cisco Systems SFS 7000P Instrukcja Instalacji Pobierz pdf (Strona 72)

Chapter 5 Hardware Diagnostic Tests

Displaying Hardware Errors

5-10

Cisco SFS 7000P Hardware Installation Guide

OL-9167-01 Rev. A0

Thu Mar 4 10:57:54 2004: Anafa2Init: a2update set to IGNORE

Thu Mar 4 10:58:16 2004: Anafa2 POST: firmware check PASSED

Thu Mar 4 19:01:55 2004: POST: SEEPROM: PASSED

Thu Mar 4 19:01:55 2004: POST: FPGA: PASSED

Thu Mar 4 19:01:55 2004: POST: SUMMIT: PASSED

Thu Mar 4 19:01:56 2004: POST: RTC: PASSED

Thu Mar 4 19:02:00 2004: POST: FAN: PASSED

Thu Mar 4 19:02:00 2004: card_startup.x : card is starting up

Thu Mar 4 19:02:00 2004: Anafa2Init: a2update set to IGNORE

You can also view POST error codes with the show diagnostic post command.

This command displays the results of each POST that executed at power-on.

SFS-7000P# show diagnostic post

======================================================================

Post Status

======================================================================

fru-slot post-status error-codes

----------------------------------------------------------------------

----------

card(1) failed 1:0:0:0

fan(1) passed 0:0:0:0

fan(2) passed 0:0:0:0

power-supply(1) passed 0:0:0:0

Step 2 Display FRU errors on your Cisco SFS 7000P switch by entering the show

diagnostic fru-error command.

SFS-7000P# show diagnostic fru-error

======================================================================

Fru-Error

======================================================================

fru-slot fru-error

----------------------------------------------------------------------

----------

card(1) _FRU_POWER_CONTROLLER_CONFIG_ERR

fan(1) none

fan(2) none

power-supply(1) none

Table 5-1 lists the hardware errors that are logged for the power supply.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78

Brak uwag

Cisco Systems SFS 7000P Instrukcja Instalacji Strona 72