Cisco Systems VG224 Instrukcja Użytkownika Pobierz pdf (Strona 19)

3-19

Cisco VG224 Voice Gateway Hardware Installation Guide

OL-5006-04

Chapter 3 Installing the Cisco VG224 Voice Gateway

Connecting Cables

Connecting the Analog Voice Interface to a Distribution Panel

To connect the multiport analog voice interface to a distribution panel, which connects to telephones,

faxes, or analog PBX equipment, use the following procedure. (See Figure 3-14.)

Cable

Use an RJ-21 cable with Amphenol 50-pin connectors (not included).

For RJ-21X/CA21A pinouts, see Table A-5 on page A-6 in Appendix A, “Cable Specifications and

Information.”

Warning

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do

not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11

port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming

call.

Statement 1042

Procedure

Step 1 Connect the RJ-21 cable from the analog voice multiport to the distribution panel.

Step 2 Secure the cable in place using the strap.

Figure 3-14 Analog Voice Connection

103118

RJ-21 cable

Distribution panel

VG224-24FXS

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

Cisco Systems VG224 Instrukcja Użytkownika Strona 19